After the sides i applied the bezel and controlpanel, only this vinyl is much thinner then the ones from the diy shop
![Undecided :-\](https://www.dragonslairfans.com/smfor/Smileys/default/undecided.gif)
So there is some of the wood pattern visible through the vinyl
I do have one printed and laminated extra, so if it bothers me too much i will install that in front..
![](http://www.opdenkelder.com/pics/minipong/182.jpg)
After i installed the controlpanel with double sided tape, i connected all the wires of the pong unit...
Houston, we have another problem
![Angry >:(](https://www.dragonslairfans.com/smfor/Smileys/default/angry.gif)
clickpic..then i checked everything again, and the only difference i could find is that i now used a smaller adapter..
clickpic..The small adapter that i used was 9v/150ma and the one i used while testing was 300ma
That however had a switchable voltage, so i like to keep that out of this build, and i replaced it wit a 750ma model
Now its running without problems, i can go on holiday without stress
![Grin ;D](https://www.dragonslairfans.com/smfor/Smileys/default/grin.gif)
So see you guys in a week orso