Mounted the speaker today, at first i wanted to mount it above the monitor in the part where the cardboard bezel wil come, but then i realised that when the top lid is installed, and there is glass in front of the monitor, the audio will be dimmed, so i hope that this position in front of the coinslot will be a solution for this.
![](http://www.opdenkelder.com/pics/minipong/239.jpg)
Time to worry about the T moulding, so i decides to make a test piece..
![](http://www.opdenkelder.com/pics/minipong/240.jpg)
Glued with the iron..
![](http://www.opdenkelder.com/pics/minipong/241.jpg)
And after cutting with the tool described earlier...
Hmm its good that its a test piece! , damage to the vinyl...
![Undecided :-\](https://www.dragonslairfans.com/smfor/Smileys/default/undecided.gif)
![](http://www.opdenkelder.com/pics/minipong/242.jpg)
![](http://www.opdenkelder.com/pics/minipong/243.jpg)
Lets see how to prevent that from happening on the real deal..
some masking tape should do the trick..
![Roll Eyes ::)](https://www.dragonslairfans.com/smfor/Smileys/default/rolleyes.gif)
![](http://www.opdenkelder.com/pics/minipong/244.jpg)
Carefully removing the tape...
![](http://www.opdenkelder.com/pics/minipong/245.jpg)
Looks alot more promissing..
![](http://www.opdenkelder.com/pics/minipong/246.jpg)
The instructions of the strip says to use sandpaper after cutting, i tried that, and the glue residue as seen in the pic above is almost totally gone, so i decided that this was enough practising, and continued with the cabinet..
![](http://www.opdenkelder.com/pics/minipong/247.jpg)
And again the strip is glued into place with the iron..
![Tongue :P](https://www.dragonslairfans.com/smfor/Smileys/default/tongue.gif)
![](http://www.opdenkelder.com/pics/minipong/248.jpg)
The corner on the other side needs a little more attention, because the corner is a bit too tight, which gave a problem with cutting..
![](http://www.opdenkelder.com/pics/minipong/249.jpg)
Anyway, masking tape ready, and time to trim the edges..
![](http://www.opdenkelder.com/pics/minipong/250.jpg)
I did trim one side, and in the curve that i was talking about, during the cutting, a chip broke out
![Angry >:(](https://www.dragonslairfans.com/smfor/Smileys/default/angry.gif)
ah well, now it has a more authentic look, with a little damage
![Cheesy :D](https://www.dragonslairfans.com/smfor/Smileys/default/cheesy.gif)
More later..