Okay, because i am not busy enough yet, lets make a start with the vector from Hard drivin's tailgate
ill start with my favorite part... Halftone.... NOT!
Better try to find me a easy way..
After some fooling around with overal distances between the dots i got a little line that has exactly the same distance:
place a copy on the calculated line above... so far so good..
and press [CTRL-D] a many times as you need dots..
i think this is just enough for the part of the exhaust pipe that i want to start..
in position after rotating it a bit and copy-ing some more dots in "wireframe" mode...
[analmode on:]
i rotated them a bit to match the original dot pattern..
[analmode off:]
And back to normal mode..
i think thats enough dots to create that part..
more later when i got time again..