Need help finding an electronic terminal

[polaris]

Hi fellas
bear with me i don't know how to get a good photo of what i need so i'll try and describe it.
i need a crimp terminal or similar which will attach physically to a material on one side of the crimp then to a wire as normal at the other end of the crimp.
i want it to have little spikes maybe that will bite through the material to attach to, when squeezed with a pliers or something. it is to attach to electroluminescent tape if that helps at all.
i don't know what terms to search for so any suggestions gratefully welcomed
 

[Etienne MacGyver]

do you mean something like this 

[polaris]

not quite, these are very small etienne, maybe 10mm by 1mm in size.
a flat spade shaped connector with four little spikes sticking up from the spade that would bite through, there are many layers to the material so i want the connector to pass through all the layers.
i'll try and take a photo that is clear.

[polaris]

sorry for rubbish pic, haven't got a macro camera at all

[Etienne MacGyver]

i saw those before, i only dont know what they are called..

I remember from the time that i did coax networks that there was something simular which was called a "vampire tap"
maybe thats helping a bit ?

[polaris]

thats certainly a good name for them, i'll try searching that

[polaris]

hmm, i've tried 'vampire' and 'piercing crimp/spade'  but no joy

any other suggestions fellas, i also wonder if there is a two part connector that connects through a material when you squeeze with a pliers or something. i just need a connector that will secure itself to the material really firmly.
any ideas you may have are welcome i'm really stuck on this project