Hi,

I've just placed an order. I sent a question afterwards, but you can disregard it. I saved a link direct to the Zaccaria decals some time ago and didn't see the message on the homepage until afterwards.

Thanks,

Rory 

Thank you. I did find my slice of t-mold a few minutes after I saw your post, it is indeed 16mm. Which poses a small problem as the T-mold I've found is only available in 15mm or 0.5 inch (1.27cm) ..... hopefully, the 1mm shortness will not look too bad on the cab. Unfortunately, there isn't much I can do about it. My Zaccaria had been abandoned for nearly 20 years, along with a number of other machines at a carnival site...inside a lorry trailer and it's only protection was a blue rubber curtain and being in the middle of the others. The T-mold had mostly rotted away, I kept a good section for when I measured up the new stuff.

Thanks again for taking the time out to measure up, I appreciate it 

It was a done as a one off favour through a friend. I don't think he would know. It was a favour through his work through someone who knew someone who knew someone who knew someone. I'll ask if there is a way to find out but, he's pretty busy usually.

It's only been printed on one side, I'm happy with the results. The new CPO looks nice too, the old one was a mess, cigarette burns and random holes drilled, so I had a new one built from scratch...thanks to Spinnhacker providing me with a vector 

Here's another photo 

Hi,

If I want a Zaccaria one, should I just place an order through the website then? Thanks.

Yes, they are 



I will put your name on my list so i can contact you when i start again.

(first need to finish the webshop pagina)

Thank You 

NO