Dragon's Lair Fans - Arcade Lifestyle

General Chat => Technical Area => Topic started by: Frame on November 17, 2014, 11:20:02 PM

Title: Zaccaria T-molding width
Post by: Frame on November 17, 2014, 11:20:02 PM

How much width is the Zaccaria's T-molding? ...in mm...

..in particualr I'm refering about the usual UP-Right cab (curved marquee).

At last I'm notice that I've 2 color in my cab: "like silver", "like gold (but not too shining)"
 

Title: Re: Zaccaria T-molding width
Post by: Etienne MacGyver on November 18, 2014, 09:56:53 AM

I know its transparant T molding with aluminium inside, i have damage on my cabinet on the bottom, and you can clearly see the aluminium inside.

gold looking might be because the transparent plastic is turning yellow over the years.

i never saw gold looking tmolding on a zacc.

Title: Re: Zaccaria T-molding width
Post by: Frame on November 18, 2014, 07:26:16 PM

All of yours Zac t-moling was replaced with a new one Etienne?

I have take same measure, and I can tell (if I don' wrong the check) the widht of all my Zac t-moldin is about 16 mm (+/- 0.5 mm error)


I will make same snapshot about...

Title: Re: Zaccaria T-molding width
Post by: Etienne MacGyver on November 18, 2014, 10:44:01 PM

No, unfortunately not.

nobody has found a source for this T molding yet.

it looks like its impossible to find  :'(

Title: Re: Zaccaria T-molding width
Post by: Frame on November 19, 2014, 06:43:15 PM

Please, Can you tell me the widht?

Title: Re: Zaccaria T-molding width
Post by: Etienne MacGyver on November 19, 2014, 07:38:04 PM

I can, but after i visit my mother, my cabinets are located there..

same for the art from the taito steeringwheel i promised somebody to look for..

Title: Re: Zaccaria T-molding width
Post by: synonym9 on April 30, 2015, 12:47:59 AM

16mm is the width of my starsplash

(http://i58.tinypic.com/24bruvo.jpg)

Title: Re: Zaccaria T-molding width
Post by: Etienne MacGyver on May 10, 2015, 04:12:14 PM

Yep, i confirm, its 16 mm for my CK (UR6 formfactor)

Title: Re: Zaccaria T-molding width
Post by: synonym9 on July 12, 2015, 10:39:18 PM

Quote from: Etienne MacGyver on May 10, 2015, 04:12:14 PM

Yep, i confirm, its 16 mm for my CK (UR6 formfactor)

UR6 Formfactor?
Is that the flat one? My one is flat.
Did´nt know that they have catalogue of standardized formfactors for T-Molding, very interesting.

Title: Re: Zaccaria T-molding width
Post by: Etienne MacGyver on July 13, 2015, 07:03:48 AM

no, the cabinets have different formfactors

http://www.zaccaria.co.uk/viewtopic.php?f=59&t=105