Dragon's Lair Fans - Arcade Lifestyle

General Chat => Technical Area => Topic started by: simplesi on June 04, 2013, 10:33:47 PM

Title: Phillips CM3388 MK2 Monitor
Post by: simplesi on June 04, 2013, 10:33:47 PM

Hi,

I recently got a Phillips M3388 MK2 Monitor to be used as a test monitor. I understand that I need to create a cable that will allow the jamma video output to connect to the 9-pin rgb d-sub input of the monitor. Has anyone done this, and does anyone have a good wiring diagram please?

Many thanks,


Si

Title: Re: Phillips CM3388 MK2 Monitor
Post by: PunkRockCaveman on June 06, 2013, 09:10:18 PM

This should be sufficient: http://www.ym2149.com/philips_pinout.jpg

Pin6 is the "switch" for rgb. If you give 5v on pin6 everything is fine ... then the device switches to rgb-mode. For the rgb-inputs (pin3-5) it might be neccessary to use 75ohm resistors for some pcbs. I build in 1k pots in my mak. Only used them a couple of times though.

Title: Re: Phillips CM3388 MK2 Monitor
Post by: martin595 on July 11, 2013, 03:57:32 AM

The Phillips M3388 MK2 Monitor is plugged in following way.


(http://img843.imageshack.us/img843/7958/aq8x.jpg)