Hi Guys, everything OK?
I finally got some capacitors and a trimmer pot, to solve the 5V issue and do the trimmer pot mod. Anyway, I replaced all caps and now I have a steady 5,27V. Possibly even a bit too high, so getting the trimmer pot installed is not a bad idea.
However, how to install it (I'm terrible at reading electronic schematics)? I've got the trimmer and there are six solder points where I can put the 3 legs (or two) of the trimmer pot, see attached picture. If someone could tell me which of the six points I use for which of the 3 legs of the pot.... that would be helpful (my assumption is A to 1 and B to 2 and forget about C).
I know I have to ditch the resistor.