The Star Wars (Atari) repair and maintenance topic

[Belike]

Replaced the pcb with the ESB kit with a "single" Star Wars, it runs fine for hours without resetting itself, so it will be the MS kit, not the edge connector.

[level42]

Sorry but you are jumping too quickly to a conclusion

The kit draws extra power so it could still be that the connection is good enough for the normal set but not for the one with the kit.....orrrrrrr, did you measure the +5V on the board at all ?

[Belike]

Sorry but you are jumping too quickly to a conclusion

The kit draws extra power so it could still be that the connection is good enough for the normal set but not for the one with the kit.....orrrrrrr, did you measure the +5V on the board at all ?

No I didn't, it was just a quick noob conclusion, just you said.

[Totomix]

Hi, I have a copckpit of Star War but when open I found a disaster!
No Pcb ( I must buy one on Ebay) No wiring harness (buy on ebay but I don't know if right one) Monitor is Hantarex (Now looking for an original Amplifon 25")
So, where I can found a manual for cable wiring harness? I found a manual but not read anything about cable assistance.
Thank you