verni QUASAR restoration

[ckong]

Hardcore! 

[Spinnhacker]

 

[anunaki]

[Flavor Flav]yeaaaaaaaaah boy[/Flavor Flav]

[vernimark]

Thank you guys, but the end is not so close... monitor and pcb are in bad conditions...
Now I'm looking for two coin acceptors blocks as shown in the pictures; Zaccaria code: A5114 

[PaulSwan]

Yeah, I can pull those off something if no one has any local to you
Paul.

[vernimark]

wow thanks. now I posted a request on the italian arcade forum... we will see in the next days

[Belike]

I might have a few, will check this weekend.

[vernimark]

Ok, next step: the monitor. these were the initial conditions after a quick cleaning

[vernimark]

Monitor is damaged. I can see that a resistor on the power board has a wrong value (probably).
I think R291 have to be a 1W 4R7 resistor, but there I found installed a R33, too different.

Then I found the BU208 short circuited, so I replaced it.

Obviously I made a complete recap.

Now I have these burned resistor and 1 transistor is missing:

R562 -> 33 ?W, burned
R466 -> 180 1/4W burned and already replaced
T463 -> BUW84 missing

do you know R562 wattage?

[PaulSwan]

The "Spare Parts List" should be in the manual packet I posted. It has R562 as 33R 0.5W. Note that it also shows R291 as 4R7 wirewound 4W (not 1W).
Paul.

[vernimark]

Thank you Paul, I used another document. colorful but without parts list 

[PaulSwan]

What's the manual you've found for it?
Paul.

[vernimark]

Thank you for the manuals!!

if someone is boring sitting in the bathroom can read the attached file and tell me if it is enough or something fundamental is missing pay attention it is highly stimulating

[PaulSwan]

You posted to the wrong topic?

[vernimark]

Uff yep!