I have the actual snubbers that are the part.  I changed all of them on both boards.  As for drive board I plugged a new one in and it still is not working for motion.  Still have an occasional issue with the main breaker tripping on start up.  My motion only want side to side initially never forward and back.  When I replaced that motor I started having more problems.  I am also going to check on the DC/ DC converter board and also some of the small parts that are goingmtowardmthe transformers.  I also heard the ssr board may have some things to do with it.  I think I can get both of those.  That would make it so I have a new drive board, ssr board and DC/DC converter board.  That would mean all newborns except the triac.  I will let you know about them.. Still in similar,situation as before.

Well I may have some relief.  I just ordered some of the driver boards we want.  Not the triac boards.  I found some and I am order like 4 of them.  I should be able to set you guys up with one, just not sure what shipping will cost.  I know they are not really available.  I found the companynthatbis set over here and they had some left.  I bought them.  Will let you know when I get them and will test out the drive board theory.  Like we said I do not think it is the triac board.  I will just keep working my way through each board I guess.

Another update on mine.  I rebuild both of my triac boards and plugged it in.  I have both motors out but plugged in to test.  As soon as I turn it on it tries to test the motors and trips the breaker (main).  If I unhook  the board it will start up.  Then I hook it back up and go into diagnostic.  I tested all my motors and will only work on my left right connection on the back connection for forward and back I do not get anything from the motors.  Obviously the motors are good.  When I checked my triac board again everything still tested good.  I have not tried the other board yet.  Any ideas why it would trip on motor warm up but not when running in diagnostics?  Also any ideas why I am getting nothing from my forward/ back connection.  I checked my wiring to the triac board from the motor and everything looks good.  I am stuck!!

Any chance you want to part with one of those working boards?  I would like one for a back up.

Thanks

I am going to get into those boards in the next few weeks.  Need to figure out what I can clean them with.  I did get a good soldering station so that the temperature is right for soldering.  By the way if you need any of the black snubbers/ film capacitors for the triac board I have the actual Panasonic part.  I had to order 100 of them and I only need 8 for the two boards.  In think I have a few extra!!!!  I will see how it works.  Just don't want to blow anymore triacs if it is something else.  Will keep you updated.

Here is the other!

I will try to take a picture of both of mine and post it.  Still working on those snubbers.  I can find the exact part but I need to order 100 of them.  May just do it and get the right ones!!  Will let you know when I do and get it done.