Very cool machine. I'm not an expert on this machine, but I will give it a shot. The movement knows three parts. 1 the engine part that makes the actual movement,2 the hardware and software on the motherboard, 3 sensors that decide how the movement should go. The last part I' m not sure about it could be that every move is just software based and not influenced by sensors.
BUT, at startup the testmovement works. So part 1 and 2 are working. That leaves three options, a specificpart of the software is corrupt ( highly unlikely), the movement option has been turned of in the setup, ( check setup and manual), last option most likely... Sensors or sensor wiring is dirty or broken.
Find the sensors by checking out the manual or just following wires, ccheck in the test mode of the software if there is a sensor, button test mode.
Good luck