106
Technical Area / Re: Crash Course - How to use a TV for monitor.
« on: April 09, 2010, 11:22:32 AM »
Looking at the images explaining what to connect to which pins on the scart connector - I'm not quite sure how to make a test setup with a TV for my Centipede board.
The pinout is as follows:
http://www.ggdb.com/KB.aspx?c=Coin-Op&s=Arcade&vid=503&kb=44
There are no Red/Green/Blue grounds mentioned in this pinout table. Is it just connecting the RGB and the composite sync from the board and it's a done deal?
Maybe the Video return pin on the board has to be connected somewhere?
I'm sorry to bring up an old post - but it seemed relevant for my question.
The pinout is as follows:
http://www.ggdb.com/KB.aspx?c=Coin-Op&s=Arcade&vid=503&kb=44
There are no Red/Green/Blue grounds mentioned in this pinout table. Is it just connecting the RGB and the composite sync from the board and it's a done deal?
Maybe the Video return pin on the board has to be connected somewhere?
I'm sorry to bring up an old post - but it seemed relevant for my question.